Migrate Easy :ERROR E000101F9 “ Cannot get write access to the hard disk drive(s).

Discussion in 'Other Acronis Products' started by anupamg, May 23, 2006.

Thread Status:
Not open for further replies.
  1. anupamg

    anupamg Registered Member

    Joined:
    May 23, 2006
    Posts:
    1
    Acronis Migrate Easy 7 build 619
    Windows 98
    Primary IDE Master Source drive 40GB
    Secondary IDE Master Destination drive 80 GB
    First time when I cloned the hard drive every thing went well but did not disconnect my old drive from the system and booted from the Secondary Master but could not get passed the log on screen. After that I have run into all sorts of problem. So I tried to do every thing all over again, Partitioned and formatted the destination drive 80Gb.
    First I was getting the massage saying that my destination drive is smaller than the source drive, which is NOT. Then I could not even reach that stage…now I am getting ERROR E000101F9 “ Cannot get write access to the hard disk drive(s).
    “Another Arconis application has write access to the hard disk drive(s). Only one Acronis application can have write access to the hard drive at a time”
    I had a trial version of True Image 9 on my PC which I managed to remove with Windows Install Clean Up utility. I have re-installed Migrate Easy the error message still pop ups and if I do manage to pass through this screen, then my destination drive is smaller than the source drive so the operation cannot proceed.
    Any help is appreciated
    Thanks
    anupamg
     
  2. Acronis Support

    Acronis Support Acronis Support Staff

    Joined:
    Apr 28, 2004
    Posts:
    25,885
    Hello anupamg,

    Thank you for your interest in Acronis System Transferring Software.

    Please accept our apologies for the delay with the response.

    Could you please create screen shots of your actions which you took to perform the cloning? Please also make a screen shot of the error message which you have received.

    Please create Acronis Report and Windows System Information as it is described in Acronis Help Post and submit a request for technical support. Attach all the collected files and information to your request along with the step-by-step description of the actions taken before the problem appears and the link to this thread. We will investigate the problem and try to provide you with the solution.

    Thank you.
    --
    Kirill Omelchenko
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.