Look'n stop and W98SE

Discussion in 'LnS English Forum' started by Bella Furia, May 30, 2006.

Thread Status:
Not open for further replies.
  1. Bella Furia

    Bella Furia Registered Member

    Joined:
    May 30, 2006
    Posts:
    53
    Hello everybody,

    i try to write in english but it is not very cool for me ; so, excuse my poor langage !

    i would to know -with look'n stop et W98SE - how to configure the access to Internet for these process (autorise to connect , autorise to open an application) :

    > MPREXE.EXE
    > EXPLORER.EXE
    > KRNL386.EXE
    > RNAAP.EXE
    > RUNDLL32.EXE

    i have the "evolued rules set" installed ; i can surf but somme pages are impossible to access for me ; for example, i can go on grc.com, i can download "leaktest" but i can not go to the "shieldsup" page ; also i can not go on MSN (even with the MSN rules)

    thank you for the answers
    and have a good day !

    Bella Furia
     
  2. Bella Furia

    Bella Furia Registered Member

    Joined:
    May 30, 2006
    Posts:
    53
    up ;)

    in fact, it is :
    RNAAPP.EXE

    thank you for the answers :)

    BF
     
  3. Bella Furia

    Bella Furia Registered Member

    Joined:
    May 30, 2006
    Posts:
    53
    up ;) :(

    nobody has W98 se and Look'n Stop o_O:eek:

    it is incredible o_O

    please, juste a little answer

    thanks
     
  4. Bella Furia

    Bella Furia Registered Member

    Joined:
    May 30, 2006
    Posts:
    53
    Up !

    Hello everybody !
    Is there someone ?

    BF
     
  5. Thomas M

    Thomas M Registered Member

    Joined:
    Jan 12, 2003
    Posts:
    355
  6. Bella Furia

    Bella Furia Registered Member

    Joined:
    May 30, 2006
    Posts:
    53
    Many thanks to you, Thomas M. :)

    i have still two questions :
    > why you don't have these process asking to go on internet :
    MPREXE.EXE
    KRNL386.EXE
    RNAAPP.EXE
    RUNDLL32.EXE

    > how you made to know the ports of an application , for ,then, made the yellow points ?

    have a good day

    BF
     
  7. Thomas M

    Thomas M Registered Member

    Joined:
    Jan 12, 2003
    Posts:
    355
    Hello Bella Furia,

    1.) On my system MPREXE.EXE is not asking for access at all.
    2.) KRNL386.EXE is blocked in both cases (works for me, though)
    3.) for RNAPP.EXE (see my point 1.)
    4.) RUNDLL32.EXE (see my point 1.)

    I use the "try & error" method ;)
    My Win98 machine is behind a router on a local LAN.
    Whenever a program asks for access, I initially block it. Then I check the log file to see what exactely was blocked. In case a program does not work, I permit the minimum of traffic by limiting the protocol/ports....

    Hope this helps,
    Thomas :)
     
Thread Status:
Not open for further replies.