LnS and NAS-01G

Discussion in 'LnS English Forum' started by dgho, Sep 28, 2007.

Thread Status:
Not open for further replies.
  1. dgho

    dgho Registered Member

    Feb 7, 2005

    I just bought the LnS and still cannot understand how to create rule o_O

    I have NAS-01G attached to my Linksys WRT54G. The Linksys connected to Internet Cable also. The NAS-01G was set up using IP and the WRT54G used IP

    How to create the rule so that LnS can work better with WRT54G and NAS-01G?

    Currently, I could still connect to internet or my NAS, but the log in LnS drives me crazy :p

    The Log:

    D-430 UDP: Any other UDP packet - UDP - [] - Ports Dest: SSDP/UPnP=1900 Src:SSDP/UPnP=1900

    Should I just ignore this log ??

    Thank you.
  2. Frederic

    Frederic LnS Developer

    Jan 9, 2003

    You can create a rule from the log with a right click on the alert.

    Then, either everything works fine and there is not need to allow these packet and you have to select the Stop sign for this new rule (so the packets will be still blocked butwith no alert), or these packets are required and there is nothing else to do.

    For both cases, the log will be cleaner after adding the rule.


Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.