Insfw driver is not found and looknstop won’t work after Installing it,how can I fix?

Discussion in 'LnS English Forum' started by blinga, Jun 26, 2007.

Thread Status:
Not open for further replies.
  1. blinga

    blinga Registered Member

    Jun 14, 2007
    I can’t use looknstop firewall on my vista OS Laptop. When I installed looknstop during the install it asked me for the diver ‘Insfw driver’ in order to complete the rest of the installation. I didn’t have it so I clicked cancel and a message appeared “Installed successfully” and it installed then this message appears when I restarted my laptop after installing Looknstop “Unable to load the Insfw driver (Error 0).” When I uninstalled the looknstop firewall this message appears “Insdriver not installed” then the message “Uninstalled successfully” appears. How can I fix this problem to get looknstop working on my vista laptop?
  2. Frederic

    Frederic LnS Developer

    Jan 9, 2003

    You should perform a clean reinstallation:
    - uninstall Look 'n' Stop from the control panel or the start menu
    - reboot
    - apply the manual uninstallation of the driver from here:
    - reboot if you changed something
    - install Look 'n' Stop again.


Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.