incrmental images same size as full?

Discussion in 'Acronis True Image Product Line' started by timmy, Mar 28, 2005.

Thread Status:
Not open for further replies.
  1. timmy

    timmy Registered Member

    Mar 24, 2005
    This may have been address before and, if so, am sorry for dup. Looked but did not find it. This is our problem: When we go to make an "incremental" image, it is the same size as a "full" image. Should it not be smaller? Esp if made only a day or so after a full image. Also, how do we check the size of the images after they have been made. We send them to the "acronis secure zone" but so far have found no way to look in that zone to see what the sizes of the images are. It is "hidden," which is fine, but is there a way we could at least check on it?
  2. Menorcaman

    Menorcaman Retired Moderator

    Aug 19, 2004
    Menorca (Balearic Islands) Spain
  3. Acronis Support

    Acronis Support Acronis Support Staff

    Apr 28, 2004
    Hello timmy,

    Thank you for choosing Acronis True Image (

    Please make sure you haven't got any software that works with hard disk intensively installed and running. Also could you please provide some info concerning the image file size and the way you used the computer between two imagings? This will allow us to investigate the problem.

    Thank you.
    Ilya Toytman
  4. tachyon42

    tachyon42 Registered Member

    Dec 26, 2004
    Defragging will certainly move sectors and cause the incremental to be very large.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.