Image through a network

Discussion in 'Acronis True Image Product Line' started by mcconnellinc, Mar 27, 2006.

Thread Status:
Not open for further replies.
  1. mcconnellinc

    mcconnellinc Registered Member

    Joined:
    Mar 27, 2006
    Posts:
    8
    I have recently downloaded the trial version of True Image. I have backed up the required partion of the slave computer and have stored the back up on the master computer.

    When I run recovery
    1. I select the archive selection located on the master computer
    2. I select restore disks/partitions
    3. I select the disks/partitions to restore on the slave computer
    4. It anylizes
    5. Then when I need to select the target location the disk/partition on the slave computer is no longer visible.

    It does mention that the locations which do not have the required space are inactive. If I wipe the OS on the slave computer (give it enough space) how will True Image be able to recognize the computer if it is not recognizable on the network (since I wiped out the OS on the slave computer)

    Thanks in advance
     
  2. seekforever

    seekforever Registered Member

    Joined:
    Oct 31, 2005
    Posts:
    4,751
    Which machine are you actually running TI on? Master or Slave? TI has to be running on the machine you are trying to Restore for the home version. I think you are doing this but I am not certain.
     
  3. mcconnellinc

    mcconnellinc Registered Member

    Joined:
    Mar 27, 2006
    Posts:
    8
    Thank you for the info. That was the problem. Thanks again.
     
Thread Status:
Not open for further replies.