I cannot access msconfig since install

Discussion in 'ProcessGuard' started by Cyborg, Jul 28, 2005.

Thread Status:
Not open for further replies.
  1. Cyborg

    Cyborg Registered Member

    Joined:
    Dec 8, 2003
    Posts:
    78
    I have installed PG but obviously I have set something incorrectly.

    I cannot go into run and use command prompts in particular msconfig.

    I uninstalled and all was well again so if I reinstall what should I be setting up?

    I think I checked all lower 4 options such as .dll etc the others I cant remember but you guys that know PG will.

    Help if you can please

    Thank you
     
    Cyborg, Jul 28, 2005
    #1
  2. Pilli

    Pilli Registered Member

    Joined:
    Feb 13, 2002
    Posts:
    6,217
    Location:
    Hampshire UK
    Put PG in learning mode and run your programs, including the "run" programs such as msconfig. rundll32 is probably the culprit and needs to be on your protected list.


    HTH Pilli :)
     
    Last edited: Jul 28, 2005
    Pilli, Jul 28, 2005
    #2
  3. Cyborg

    Cyborg Registered Member

    Joined:
    Dec 8, 2003
    Posts:
    78
    I really hate those "sulprits" :rolleyes:

    I will give the learning mode a bash ,

    Thank you
     
    Cyborg, Jul 28, 2005
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...