HDD SMART temp problem

Discussion in 'hardware' started by Iangh, Dec 23, 2008.

Thread Status:
Not open for further replies.
  1. Iangh

    Iangh Registered Member

    Joined:
    Jul 13, 2005
    Posts:
    719
    Location:
    Melbourne, Australia
    I would like to use a programme such as Speedfan to monitor my HDD temp and flash a warning when it gets too hot.

    Problem is that the temperature reads fine for a while and then gives me a stupid reading like 3C or 255C as opposed to the usual 40C.

    Is there anything I can do about this?

    I have tried other temp programmes so I know it is nothing to do with Speedfan.

    It is a Hitachi Travelstar HTS424040M9AT00.

    Ian
     
  2. Mrkvonic

    Mrkvonic Linux Systems Expert

    Joined:
    May 9, 2005
    Posts:
    9,316
    These monitors can be funny like that.
    Just ignore them. Try a newer version of the program, might solve the issue.

    I've had sensors reading -127C and fans spinning at 80,000 rpm! After I installed a new version of speedfan, things got normal :)

    Mrk
     
Loading...
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.