Hard drive problem with Snap Deploy 2

Discussion in 'Other Acronis Products' started by tanGee, Dec 23, 2007.

Thread Status:
Not open for further replies.
  1. tanGee

    tanGee Registered Member

    Dec 23, 2007
    EDIT 2: Solved - I had originally the second drive plugged into SATA port 5, as it was the easiest one to reach...but I fiddled and got it into SATA 2 and while I still saw the error, it didn't halt on it...weird.

    I am trying to PXE boot the Master Image Creator and it froze at the "Loading, Please Wait" message. Following other's advice, I hit F11 and removed the "quiet" kernel parameter, and I got the error

    "ATA abnormal status 0x7f..."

    After unplugging the second hard drive the Creator booted fine. I need this hard drive plugged in however to create the image on. I have read some posts about this and it looks like it could be a raid thing (although I dont have raid configured, and can't find anything to do with it in my BIOS...)

    Is there anything I can do to resolve this?

    Thanks in advance...

    EDIT: I have 2 SATA hard drives, both 320GB and no IDE drives at all plugged in...if it makes a difference :)
    Last edited: Dec 23, 2007
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.