good configuration to use PG with KIS 6.0 or KAV 6.0?

Discussion in 'ProcessGuard' started by carioca, Jul 6, 2006.

Thread Status:
Not open for further replies.
  1. carioca

    carioca Registered Member

    Joined:
    Jul 9, 2005
    Posts:
    96
    Hi! community and Support,
    o_O
    What's a good configuration to use PG with KIS 6.0 or KAV 6.0? How to avoid PG block them? I have read as a good configuration at PG support forum is "enable all 4 global protection options, verify that Learning Mode is enabled and reboot again. (Then PG will learn the settings that your startup apps need with regard to those global prot. options.)" But which 4 global protection options in order to kis or kav 6.0 works smoothly ? Do you have some advice or hints for beginners users (non expert ones)? Have a nice day! Best Regards.*puppy*
     
  2. siliconman01

    siliconman01 Registered Member

    Joined:
    Mar 6, 2003
    Posts:
    780
    Location:
    West Virginia (USA)
    On Windows XP-SP2 Home Edition, KIS 6.0, PG V3.4 Final

    The only Protection entry I have for KIS 6.0 is program AVP.EXE with the following options check marked in PG for AVP.EXE:

    Protect From:
    Termination
    Modification

    Authorize to:
    Terminate
    Modify
    Read

    Other:
    Install Global Hooks
    Install Drivers/Services

    I have all Global Protection options active in PG; Execution Protection active; and Protection Enabled.

    Have found this works quite well together thus far.
     
Thread Status:
Not open for further replies.