Error message when restoring.

Discussion in 'Acronis True Image Product Line' started by babac, May 13, 2007.

Thread Status:
Not open for further replies.
  1. babac

    babac Registered Member

    Joined:
    Sep 16, 2006
    Posts:
    372
    Location:
    Montr?al,Qc.Ca
    Hi everyone,
    When I restore my system with the Acronis Boot Disk, during the Acronis Disk loading, I can see this message :USB device not accepting new address =2(error-110)

    One of my backups is on external USB disk .However, I do not have any problem restoring a backup from that disk.

    I,m just intrigued by that message.
    Thank you!
     
  2. Acronis Support

    Acronis Support Acronis Support Staff

    Joined:
    Apr 28, 2004
    Posts:
    25,885
    Hello babac,

    Thank you for choosing Acronis Disk Backup Software.

    Please try booting with "acpi=off noapic" parameter as it is described in Acronis Help Post.

    Please also note that this message not necessary indicates a problem, it could happen that it is referred to one of the unused USB ports. Thus, if you can access the image archive stored on the external USB device you can ignore this message.

    Thank you.
    --
    Aleksandr Isakov
     
  3. babac

    babac Registered Member

    Joined:
    Sep 16, 2006
    Posts:
    372
    Location:
    Montr?al,Qc.Ca
    Hi Aleksandr,
    Thanks for your answer.I decided to ignore the message.It's going to be much easier!
     
Thread Status:
Not open for further replies.