Disk Director 10 can't see my new SATA II drive

Discussion in 'Acronis Disk Director Suite' started by chobbney, Oct 22, 2006.

Thread Status:
Not open for further replies.
  1. chobbney

    chobbney Registered Member

    Oct 22, 2006

    I've just replaced my OS IDE drive with a Raptor SATA/150 drive. I've connected it into the SATA II connector on my Asrock 939Dual-SATA2 motherboard because I want to use the other two SATA/150 connectors far a RAID setup sometime soon.

    I've installed Windows XP and the drive (and a 2nd IDE drive) are working fine.

    However, when I boot into the Disk Director 10 Boot CD I can only see the IDE drive. I don't get an error - I just don't see the SATA drive. The drive is, obviously, visible and bootable - according to the BIOS.

    Anybody any ideas?


    [edit] Version 2117 fixed this problem.
    Last edited: Oct 22, 2006
Thread Status:
Not open for further replies.