Delete sheduled tasks with RA

Discussion in 'NOD32 version 2 Forum' started by Roma, Jun 29, 2005.

Thread Status:
Not open for further replies.
  1. Roma

    Roma Guest

    How to delete (sheduled)tasks on clients computers with RA ?
     
  2. alglove

    alglove Registered Member

    Joined:
    Jan 17, 2005
    Posts:
    904
    Location:
    Houston, Texas, USA
    1. In the big Clients list, right-click on the computer you want to modify and choose Configuration.
    2. Check "Use the downloaded configuration in the new configuration task.
    3. Hit the "New Task" button.
    4. Hit the "Edit" button. You should now get the Configuration Editor.
    5. Since all you want to do is to Delete a task, you do not want to change other settings. Go to Edit --> Unmark All. This will make all the little "boxes" grey.
    6. In the Configuration List, go to General --> Settings --> Scheduler --> "Scheduler/Planner: Total ?/0 (tasks/to delete)". Highlight this and hit the "Edit button" on the right.
    7. In the list of tasks, highlight the task you wish to delete, and hit the "Mark for deletion" button.
    8. If you wish to keep other tasks out of the update, highlight them and choose "Remove from list". This will leave the other tasks alone.
    9. Hit "Close" when you are finished doing this.
    10. In the big Configuration Editor screen, you should now see that some of the boxes have turned blue. This is what will be changed.
    11. Hit the "Back to Console" button. When asked if you wish to save changes, say "Yes".
    12. Now that you are back the Configuration for Clients screen, hit "Next >".
    13. Select the computers that have the changes. Hit "Next" after you have done this.
    14. Now submit the update task. It will take several minutes before the computer picks up the update. You may follow it in the "Tasks" tab.

    Hope this helps.
     
  3. Roma

    Roma Guest

    BIG BiG Thanx :))
    Now other question :))
    how to delete a specific task on 100 computers for example ? or i need to make the same (step ) for ervery computer
     
  4. zashita

    zashita Registered Member

    Joined:
    May 17, 2005
    Posts:
    309
    Once you finished with the configuration editor save it and you should return automatically to the configuration task. There, ou will choose what computer(s) will receive it. You only need to choose the target(s).
     
  5. Roma

    Roma Guest

    Thanx a lot !!!
     
  6. zashita

    zashita Registered Member

    Joined:
    May 17, 2005
    Posts:
    309
    It is harder to explain how to deploy than to try it :)
     
Thread Status:
Not open for further replies.