Creating Boot Disks with Panda AV

Discussion in 'ProcessGuard' started by Platoface, May 9, 2004.

Thread Status:
Not open for further replies.
  1. Platoface

    Platoface Registered Member

    Joined:
    Apr 22, 2004
    Posts:
    2
    I have installed Panda Titanium AV 2004 along with PG 2.0 and am wanting to create boot disks with the Panda software "Safedisk.exe" utility. But I keep getting blocked by PG. Please advise what settings I made need to change. Also I cannot open Panda AV interface... I kind of have to trick PG into letting me. I know I have not given alot of pertinent info here but i am hoping that someone can tell me what I am doing wrong by asking the right questions. ( I have not slept much lately, so if this whole post is rather vague I will try and clarify if you like after a good rest.) Thanks. Oh, and I love PG and WG, and TDS3! Just a newbie at these progs.

    :oops:
     
  2. Dardasaba

    Dardasaba Registered Member

    Joined:
    Feb 16, 2004
    Posts:
    38
    Location:
    Israel
    Just disable PG, create the boot disk, and then re-enable PG.
     
  3. Platoface

    Platoface Registered Member

    Joined:
    Apr 22, 2004
    Posts:
    2
    After getting 8 hrs. of sleep.... that came to my fooged mind. Thanks for the reply. I'll never PUI again. :D
     
Thread Status:
Not open for further replies.