Corrupt Master File Table after using Acronis Disk Director to create partition

Discussion in 'Acronis Disk Director Suite' started by JeremyS, Jan 19, 2009.

Thread Status:
Not open for further replies.
  1. JeremyS

    JeremyS Registered Member

    Joined:
    Jan 19, 2009
    Posts:
    1
    Last night I downloaded a trial of Acronis Disk Director and used it to create a new partition. I think 7GB is all it the trial would allow me to create. I had 54GB free. The drive was a WD 160GB with Vista installed. After using Acronis Disk Director to do this my drive now reports a Corrupt Master File Table and will not boot. I get the MFT message when I put the drive in another computer. Any advice?

    Thanks.
     
    JeremyS, Jan 19, 2009
    #1
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...