Copy to new hardware won't boot.

Discussion in 'Paragon Drive Backup Product Line' started by fred3, Aug 21, 2013.

Thread Status:
Not open for further replies.
  1. fred3

    fred3 Registered Member

    Joined:
    Aug 21, 2013
    Posts:
    3
    Location:
    United States
    I've been using Drive Copy 11 Pro and now Drive Copy 12 Pro.
    I'm trying to move a hard drive install from one computer to another.
    Both have XP Pro on them.
    I can make a copy of the old drive onto the new drive.
    But then at boot, the system reboots right after the Windows splash screen appears.
    At one point I got the impression that I needed new SATA disk drivers, so I created a boot disk with them on it. I can't tell that they were used and this didn't seem to help.
    I ran the XP disk command line and did a fixmbr and fixboot but that did no good either.
    I've used this before but it's not working this time.
     
  2. SIW2

    SIW2 Registered Member

    Joined:
    Sep 6, 2009
    Posts:
    1,572
    If the hardware is different windows will likely not boot. You could try the paragon p2p adjust. It will tell you if you need drivers for the os on the new hardware. It will also inject them for you.
     
Loading...
Thread Status:
Not open for further replies.