control center profile has changed...

Discussion in 'NOD32 version 2 Forum' started by citycruiser, Dec 14, 2006.

Thread Status:
Not open for further replies.
  1. citycruiser

    citycruiser Registered Member

    Joined:
    Oct 7, 2006
    Posts:
    7
    Location:
    Hamburg,DE
    after every scan with NOD32 2.70.16 in-depth analysis, I get the information "control center profile has changed" and I have to safe or quit.
    Every time I safe...

    Pls. tell me, why do I get these information after all full scans with NOD32 2.7?
    Never see this before with version 2.5.

    I have installed NOD in "standard config." and no personal extra settings.
    I am wondering, is all okay with my installation?

    thks and regards
    Citycruiser
     
    Last edited: Dec 14, 2006
  2. Thankful

    Thankful Savings Monitor

    Joined:
    Feb 28, 2005
    Posts:
    4,663
    Location:
    New York City
    My guess would be you haven't saved a control center profile yet.
    Instructions for doing this can be found here:
    https://www.wilderssecurity.com/showthread.php?t=37509&page=2
    Please start with post # 47.
    Under the Setup Tab, make sure 'Enable Anti-Stealth Technology',
    'Potentially Unsafe Applications', 'Potentially Unwanted Applications'
    are all checked.

    Instructions on saving profiles are given in post #60.
     
  3. citycruiser

    citycruiser Registered Member

    Joined:
    Oct 7, 2006
    Posts:
    7
    Location:
    Hamburg,DE
    @Thankful

    thank you for these instructions!
    I try out with these settings.
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.