Cloning SCSI Disk to an Array on a E200 Controller

Discussion in 'Acronis True Image Product Line' started by kiske, Sep 27, 2007.

Thread Status:
Not open for further replies.
  1. kiske

    kiske Registered Member

    Joined:
    Sep 27, 2007
    Posts:
    3
    Hi,

    I've an HP Proliant ML350 G5 server, and at this time I've installed only one SCSI 18Gb Disk over an old Adaptec 29160 controller.
    In few days I'll get two hotswap disks to connect in the E200 SmartArray controler...
    What's the best true image software version to do the clone from the old SCSI disk to the new disk array?

    Thank you in advance...
     
  2. dja2k

    dja2k Registered Member

    Joined:
    Feb 15, 2005
    Posts:
    2,040
    Location:
    South Texas, USA
    Try True Image Version 10 but not the new 11. :)

    dja2k
     
  3. kiske

    kiske Registered Member

    Joined:
    Sep 27, 2007
    Posts:
    3
    "try" means you're not sure? o_O
     
  4. dja2k

    dja2k Registered Member

    Joined:
    Feb 15, 2005
    Posts:
    2,040
    Location:
    South Texas, USA
    I mean don't use 11 cause its more likely it will not see your hard drives during the BOOTCD with recent problems it has encountered. Those are old SCSI controllers and I am not sure if they will be seen, but I have used True Image 10 in a lot a computers old and new without problems, so True Image 10 might be your best choice. You can contact Acronis Customer Service or PM the Acrnois Rep around this forum.

    dja2k
     
  5. kiske

    kiske Registered Member

    Joined:
    Sep 27, 2007
    Posts:
    3
    Many thanks!
     
Thread Status:
Not open for further replies.