Cloning from IDE to SATA raid 1

Discussion in 'Acronis True Image Product Line' started by Plutonius, Feb 22, 2007.

Thread Status:
Not open for further replies.
  1. Plutonius

    Plutonius Registered Member

    Joined:
    Feb 22, 2007
    Posts:
    1
    I installed a SATA raid 1 in a computer and now I am attempting to clone the original IDE drive to the SATA raid 1. The SATA raid 1 has been formatted with the raid drivers and is visible as drive e: when I boot off of the original IDE drive. The IDE drive shows up as drive c: and is running windows 2k. Can TI 10 move everything from the IDE drive to the SATA raid 1 drive and can the SATA raid 1 drive be bootable ? If so, what procedure should I use ?
     
  2. shieber

    shieber Registered Member

    Joined:
    Oct 27, 2004
    Posts:
    3,710
    If the SATA RAID array is reconized by the Boot CD, then you should be able to treat the RAID array just like it was a normal single HDD, which is how the RAID driver is supposed to make the array look to the system.

    The only issue would be if the SATA or RAID driver was not supported by the BOOT CD OS -- not all hardware is supported but lots of SATA and RAID is.
     
Thread Status:
Not open for further replies.