Can't get config loaded

Discussion in 'Paragon Early Adopter Program' started by Dingus, Jun 19, 2013.

Thread Status:
Not open for further replies.
  1. Dingus

    Dingus Registered Member

    Joined:
    Jun 19, 2013
    Posts:
    2
    Location:
    Scotland
    I've been tring to get your program to load without success.
    Can you help?

    I get this result:


    C:\Paragon\Paragon_uEFI_iSCSI>escsicfg.bat --show

    Available Disks:

    Drive #0
    Model: WDC WD1500ADFD-00NLR Serial: WD-WMAP41914347
    Drive #1
    Model: WDC WD30EZRX-00DC0B0 Serial: WD-WCC1T0120198
    Drive #2
    Model: WDC WD15EADS-00P8B0 Serial: WD-WMAVU0016669
    Drive #3
    Failed to get ATA model and serial for drive #3. Non-ATA devices are not support
    ed.
    Drive #4
    Failed to get ATA model and serial for drive #4. Non-ATA devices are not support
    ed.
    ---------
    Available NICs:

    Adapter #0
    Friendly name: Main Router
    Description: Atheros L1 Gigabit Ethernet 10/100/1000Base-T Controller #2
    - McAfee Core NDIS Intermediate Filter Miniport
    DHCP:eek:ff
    MAC:00:1e:8c:d6:11:aa
    Ipv4: 152.251.1.202
    Subnet mask: 0.0.0.0

    C:\Paragon\Paragon_uEFI_iSCSI>escsicfg.bat --install e: 1 0

    ---------
    Generating config for disk #1 and nic #0
    Failed to create the config! You may manually create escsi.config in installatio
    n dir and rerun escsicfg with --copy switch

    C:\Paragon\Paragon_uEFI_iSCSI>
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.