Blackspears Settings

Discussion in 'NOD32 version 2 Forum' started by Albinoni, Mar 7, 2006.

Thread Status:
Not open for further replies.
  1. Albinoni

    Albinoni Registered Member

    Joined:
    Feb 17, 2005
    Posts:
    709
    Location:
    Perth, Western Australia
    Ok I am sure this Q had been asked before but I'm going to ask it again, perhaps changes have been made and its possible.

    My question is, is it possible to save Black Spears settings for NOD32 ?
     
  2. Lollan

    Lollan Registered Member

    Joined:
    Feb 2, 2006
    Posts:
    288
  3. Benvan45

    Benvan45 Registered Member

    Joined:
    Jul 27, 2004
    Posts:
    556
    I have always used the export function from the registry:
    HKEY_LOCAL_MACHINE\SOFTWARE\Eset just right-click on Eset and export......it works great! After a clean install, just double-click on the exported reg. setting and you are all done. The only thing to remember is, when an upgrade has been taken place, don't forget to export the new settings again, otherwise you'll go back to the prior version........Just ran into this this week when upgrading to 2.51.20 through a fresh download. I just put the exported file back, but after install, the old version 2.50.45 showed up again and I kept wondering what happened, but a new export after an upgrade, does the trick.

    Good luck!
     
  4. FirePost

    FirePost Registered Member

    Joined:
    Jul 29, 2005
    Posts:
    212
  5. Benvan45

    Benvan45 Registered Member

    Joined:
    Jul 27, 2004
    Posts:
    556
    Will give this a try also.......thanks for the tip!
     
Thread Status:
Not open for further replies.