BelArc Advisor 6.1 (Informational only)

Discussion in 'ProcessGuard' started by spy1, Feb 4, 2004.

Thread Status:
Not open for further replies.
  1. spy1

    spy1 Registered Member

    Joined:
    Dec 29, 2002
    Posts:
    3,139
    Location:
    Clover, SC
    If you're running PG and you want to get BA v6.1 to install, you're going to have to UN-check "Block Drivers" to do so. (Remember to turn it back on afterwards!).

    The program functions normally with "Block Drivers" check-marked after it's been installed - and does not generate any PG log entries when you run it. Pete
     
Thread Status:
Not open for further replies.