Bart PE CD (Mustang's Instructions)

Discussion in 'Acronis True Image Product Line' started by The_Flying_Scot, May 23, 2007.

Thread Status:
Not open for further replies.
  1. The_Flying_Scot

    The_Flying_Scot Registered Member

    Joined:
    May 7, 2007
    Posts:
    26
    Hi
    Just want to confirm that after I have produced the CD I can safely delete all the folders on my drive that I had to create in order to make the Bart PE CD, e.g. E:\WinXP, C:\pebuilder3110a etc. as detailed in Mustang's instructions?

    Regards
    The_Flying_Scot
     
    The_Flying_Scot, May 23, 2007
    #1
  2. thomasjk

    thomasjk Registered Member

    Joined:
    Jul 22, 2005
    Posts:
    1,482
    Location:
    Charlotte NC
    Yes, unless you want to build it again. I would keep the E:\WINXP (I assume this is your XP source) and C:\pebuilder3110a. You need these two if you decide to build an other CD.
     
    thomasjk, May 23, 2007
    #2
  3. The_Flying_Scot

    The_Flying_Scot Registered Member

    Joined:
    May 7, 2007
    Posts:
    26
    Hi Tom
    Thanks for the info.

    Regards
    The_Flying_Scot
     
    The_Flying_Scot, May 24, 2007
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...