Assuming v10 Rb RX is similar to v9, any settings I need to enable because of my SSD?

Discussion in 'backup, imaging & disk mgmt' started by ratchet, Jan 20, 2013.

Thread Status:
Not open for further replies.
  1. ratchet

    ratchet Registered Member

    Joined:
    Feb 20, 2006
    Posts:
    1,988
    I'm again assuming it will recognize my systems setup? Also, can snapshots be defraged (with Rb's dfrg) on a SSD? I realize it isn't exactly a true defrag.
     
    ratchet, Jan 20, 2013
    #1
  2. MarcP

    MarcP Registered Member

    Joined:
    Jun 9, 2009
    Posts:
    743
    I had v10 on my machine for a few days. I'm on an SSD as well. Didn't have any problems.
     
    MarcP, Jan 20, 2013
    #2
  3. TheRollbackFrog

    TheRollbackFrog Imaging Specialist

    Joined:
    Mar 1, 2011
    Posts:
    4,954
    Location:
    The Pond - USA
    Ratchet, there's nothing special to do in relation to SSDs... RBrx takes care of all that during installation. The control screens are mostly the same (now resizable :D ) and contain a few new TABs for option use (same options, different presentation). It looks a lot like the old system but a bit more intuitive.
     
    TheRollbackFrog, Jan 20, 2013
    #3
  4. ratchet

    ratchet Registered Member

    Joined:
    Feb 20, 2006
    Posts:
    1,988
    Thanks, going to try it!
     
    ratchet, Jan 20, 2013
    #4
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...