After restore, Hard drive doesn't show correct size???

Discussion in 'Acronis True Image Product Line' started by rimshot609, Apr 9, 2009.

Thread Status:
Not open for further replies.
  1. rimshot609

    rimshot609 Registered Member

    Apr 9, 2009
    I bought a new 1 terabyte drive and restored my full backup to this drive. The old drive was 700Gig. After I completed the restore it looks like my 1 Terabyte drive is only 700GIG now. What happened to the remaining 300gigs? :eek:
  2. GroverH

    GroverH Registered Member

    May 10, 2006
    Massachusetts, USA
    One option would be to perform the restore again but choose the partitions rather than checking the disk option. This would allow you to resize each partition.

    Another option by DwnNdrty is to
    Try the Secure Zone trick. In essence it goes something like this:
    1. Use the TI Rescue CD to do this.
    2. Boot with the cd and choose to make a Secure Zone. The size doesn't matter.
    3. Be sure to NOT accept the default to activate the Startup Recovery Manager.
    4. After the SZ is made, go right back into Manage the SZ and choose to Remove it.
    5. When asked what to do with the space, choose to append it to the drive. All of the lost space will be appended, not just what was the SZ.
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.