Acronis Migrate Easy- after cloning only one drive visible.

Discussion in 'Other Acronis Products' started by AaLF, Jul 11, 2009.

Thread Status:
Not open for further replies.
  1. AaLF

    AaLF Registered Member

    Joined:
    Feb 20, 2005
    Posts:
    986
    Location:
    Sydney
    Just used Acronis Migrate Easy to clone a SATA HDD to a 2nd sata HDD. ( Not the C-Drive & clone HDDs are for storage only.)

    Once finished I can see only one of the drives thru START>MY COMPUTER. Both drives are visible thru CONTROL PANEL>DISK MNGMNT.

    What is the remedy?
     
Thread Status:
Not open for further replies.