Acronis 8 Enterprise + Promise SX4

Discussion in 'Acronis True Image Product Line' started by spektra, Mar 21, 2005.

Thread Status:
Not open for further replies.
  1. spektra

    spektra Registered Member

    Joined:
    Mar 18, 2005
    Posts:
    1
    I've tried to recover a ML110 Server (HP Compaq) with a S-ATA RAID controller (Promise SX4). But Acronis only recognizes the physikal Disks but not the RAID i have configured.

    I get the backup to a single disk and can boot from it (when the RAID is a JBOD on a single disk), but that's not what i want of my backup solution. Is there a solution for the problem? Or is it impossible?

    thx alot
     
  2. VPTECH

    VPTECH Registered Member

    Joined:
    Mar 11, 2005
    Posts:
    18
    We had a simular issue with a promise controller. Ours would restore but when you rebooted it would do nothing but blue screen.

    We restored the image to a single drive then threw in the second and rebuilt the array and everything was ok. Granted ours was IDE raid and not sata. We have encountered a lot of issues with SATA and Acronis.

    Good Luck.
     
  3. Acronis Support

    Acronis Support Acronis Support Staff

    Joined:
    Apr 28, 2004
    Posts:
    25,885
    Hello spektra,

    Thank you for your interest in Acronis True Image Enterprise Server (http://www.acronis.com/enterprise/products/ATIESWin/).

    First of all please make sure that you have the latest build (941) of Acronis True Image Enterprise Server available at http://www.acronis.com/enterprise/support/updates/. Please create sysinfo.txt and send it to support@acronis.com along with the link to this thread (please see https://www.wilderssecurity.com/showthread.php?t=55317 for the detailed instructions). We will certainly help you with the solution.

    Thank you.
    --
    Irina Shirokova
     
Thread Status:
Not open for further replies.