Sysinspector issue

Hi,

Can anyone confirm this? Running a clean install of Windows 7 x64 and the 64-bit version of Eset SS 5.0.65.0. Whenever I run Sysinspector, either from the main program or right from the Eset folder, the program just sits there and never completes. I have to kill the task to get it to stop.

Thanks,

Joe

 

No problems here. However, needs a longer time until complete.
Win 7 x64

 

No problems here either on Win 7 X64.

 

How long? I am talking upwards of 40 minutes.

Joe

 

Ok after about an hour SysInspector finaly finished. This time is of course unacceptable.

Joe

 

About 4 min.

 

I was asked by support to run it in safe mode but that made it worse. It never completed even AFTER one hour and I still needed to end task to end the program. I am running SysInspector now for the hour or so it takes and I will send support a copy of the log file when it is done to see what is going on.

Joe

 

Between 4 - 5 seconds on my PC.
@Joe, have you got any other security software installed?
Is this a clean installation of the beta or an upgrade from a previous version?

 

Just the default windows security stuff. Clean install of Windows 7 x64. Trying to figure out why things are going so badly with the beta test. This is the only piece of beta software on here.

Have another issue posted below.

Joe

 

I believe I have my trusted zone setup properly however every 1/2 hour or so I get a warning from the firewall that it "Detected a port scanning attack" and it's always from a PC on my home network. I tried to add all the local IP addresses wherever I could to prevent this warning but it keeps coming.

Any ideas?

Joe

 

Have you added your local address range or subnet to the predefined zone 'Addresses excluded from active protection (IDS)' ?

 

Hello,

For those of you who found that ESET SysInspector logs were taking a long time to finish being generated, what sort of hardware are you running the public beta on?

Regards,

Aryeh Goretsky