codes for scripted install

Discussion in 'General Returnil discussions' started by KINFOLK, Apr 18, 2011.

Thread Status:
Not open for further replies.
  1. KINFOLK

    KINFOLK Registered Member

    Joined:
    Jan 24, 2010
    Posts:
    7
    Are there codes for the following settings?

    Do not warn when exit virtual mode (ON)
    Automatically rescan after A/v update (OFF)

    I see no code numbers for these settings in Returnil Commander. I am trying to set these via an install with a params file.

    Thanks
     
    KINFOLK, Apr 18, 2011
    #1
  2. Coldmoon

    Coldmoon Returnil Moderator

    Joined:
    Sep 18, 2006
    Posts:
    2,981
    Location:
    USA
    Hi,
    Apologies for the delayed reply.

    There is no code for this one as it is controlled at the client. To change the default, you will need to set this on each copy.

    The code for this one is: "20212 SEC_SCHED_UPDATE" and can be set via the PARAM file.

    Mike
     
    Coldmoon, Apr 19, 2011
    #2
  3. KINFOLK

    KINFOLK Registered Member

    Joined:
    Jan 24, 2010
    Posts:
    7
    Hello,

    One more - is there a code for "Allow Programs to run normally"?

    I am setting 20200=0 , but get "Trust system services from real disk only"

    Bob
     
    KINFOLK, May 2, 2011
    #3
  4. Coldmoon

    Coldmoon Returnil Moderator

    Joined:
    Sep 18, 2006
    Posts:
    2,981
    Location:
    USA
    Hi Bob,
    I sent a reply via e-mail but am also posting here for others interested in the same question:

    Mike
     
    Coldmoon, May 4, 2011
    #4
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...