Marcium Reflect and NIS 2011

Discussion in 'backup, imaging & disk mgmt' started by squid13, Feb 6, 2011.

Thread Status:
Not open for further replies.
  1. squid13

    squid13 Registered Member

    I have question about NIS 2011. Do you have to have Tamper Protection disabled in NIS 2011 for Macrium Reflect to work right. I know system restore in windows will not work if it is activated, so I was wondering if imaging and restoring an image would be affected by having it enabled. I'm using Windows 7 Pro 64 bit.
     
    squid13, Feb 6, 2011
    #1
  2. malexous

    malexous Registered Member

    Having it enabled should not cause a problem with Macrium Reflect.
     
    malexous, Feb 7, 2011
    #2
  3. Raza0007

    Raza0007 Registered Member

    I have been using Macrium with NIS 2011 (temper protection enabled) and have had no problems.

    I have not used the windows system restore in a while, but I am surprised to learn that it interferes with NIS 2011 temper protection.
     
    Raza0007, Feb 7, 2011
    #3
  4. squid13

    squid13 Registered Member

    Thanks to everyone for your responses. I'll put tamper back in and let it run.
     
    squid13, Feb 8, 2011
    #4
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice