Problem with raid 0 config

Hi, I currently have a single 160gb sata drive. I am trying to make and image of it and put it back on to a raid config with 2 160gb sata drives. I set up the raid via my mb and true image recognizes it and lets me restore to it. However once i restore it won't start windows from the raid. It will get bios boot and then the little white line fills across the bottom of the screen then it reboots. It just does this over and over.

Any ideas?

sorry if this is a frequent question but i did not see any posts about it.


Thanks

 

Hi cardman150,

I would say that this is lack of drivers for the RAID controller in the system. Have a look at this previous thread. It describes how to transfer your operating system from a single hard drive to a RAID array.

_Kento_