Physical Memory Allerts

Discussion in 'ProcessGuard' started by WilliamP, Sep 23, 2004.

Thread Status:
Not open for further replies.
  1. WilliamP

    WilliamP Registered Member

    Joined:
    Jun 1, 2003
    Posts:
    2,208
    Location:
    Fayetteville, Ga
    I am getting a lot of allerts where PG is stopping an exe. from accessing physical memory. When I went to protection the three exe's are all allowed to access physical memory. I also have one wanting to install a driver and it is allowed. What needs to be done?
     
    WilliamP, Sep 23, 2004
    #1
  2. WilliamP

    WilliamP Registered Member

    Joined:
    Jun 1, 2003
    Posts:
    2,208
    Location:
    Fayetteville, Ga
    My most humble apology. It is working like a champ. It is setting the allert before setting the allow in protection. I am still in the learning mode. When I clear the allerts then reboot they don't show up again.
     
    WilliamP, Sep 23, 2004
    #2
  3. Jason_DiamondCS

    Jason_DiamondCS Former DCS Moderator

    Joined:
    Nov 11, 2002
    Posts:
    1,046
    Location:
    Perth, Western Australia
    Yes, a small thing you have to notice. Learning mode doesn't actually allow everything through the first time. Rather it gets a message that something has been blocked THEN allows it.
     
    Jason_DiamondCS, Sep 23, 2004
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...