P.G.v3.410 "Check Version" fails

Discussion in 'ProcessGuard' started by P.SCD, Sep 1, 2006.

Thread Status:
Not open for further replies.
  1. P.SCD

    P.SCD Registered Member

    Joined:
    Mar 27, 2006
    Posts:
    2
    Location:
    France
    Hello
    Checking for newer version fails with an error message: Download updates Error conecting to the internet. (even in learning mode)
    It seem to be due to Zone Alarm firewall
    Anybody got the same problem or have a solution ?
    Thanks
     
  2. tonyjl

    tonyjl Registered Member

    Joined:
    May 25, 2004
    Posts:
    287
    Hi P.SCD.

    Allow Procguard.exe to connect to www.diamondcs.com.au (64.91.255.87). I have ZA Pro,i think there's a glitch in it coz i allow PG to connect to remote port 80 and ZA blocks it,logs it as PG tried to connect to remote port 80 o_O Go figure.
    So i just allow PG to connect DCS's web site on any port and that works.
     
  3. P.SCD

    P.SCD Registered Member

    Joined:
    Mar 27, 2006
    Posts:
    2
    Location:
    France
    Thanks a lot for the tip but, I just updated Z.A. to its very new version 6.5.737.000 and now, it works normally. :thumb:
    Good evenning to everybody :D
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.