Imaging problems with Quantum Snap Units

Discussion in 'Acronis True Image Product Line' started by RidgeSupport, Nov 21, 2006.

Thread Status:
Not open for further replies.
  1. RidgeSupport

    RidgeSupport Registered Member

    Joined:
    Nov 21, 2006
    Posts:
    3
    Running the Acronis Boot disk from 9.1 and attempting to image to an older Quantum Snap unit. It was originally a 20GB NAS unit, and with a new firmware upgrade, we upgraded it to a 320GB Snap unit. Acronis has no issues seeing the Snap unit, but has issues writing to it. Never had any issues before. When trying to create an image, we get an error, bad filename or location. On occasion we get a login prompt, but there is no authentication of any type on the SNAP setup.

    Has anyone else had similar issues with these Snap units?
     
    RidgeSupport, Nov 21, 2006
    #1
  2. RidgeSupport

    RidgeSupport Registered Member

    Joined:
    Nov 21, 2006
    Posts:
    3
    BUMP...anyone have any similar issues?
     
    RidgeSupport, Nov 27, 2006
    #2
  3. bodgy

    bodgy Registered Member

    Joined:
    Sep 22, 2005
    Posts:
    2,387
    Location:
    Qld.
    do you have full duplex enabled?


    Colin
     
    bodgy, Nov 27, 2006
    #3
  4. RidgeSupport

    RidgeSupport Registered Member

    Joined:
    Nov 21, 2006
    Posts:
    3
    On the SNAP units? Or the machine we're imaging from? On the SNAP, definitely yes. On the machine, I'd say yes. We've tried from several machines, some that I know are full duplex and others I'm not so sure about, but I see no reason why they wouldn't be.
     
    RidgeSupport, Nov 28, 2006
    #4
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...