I have a problem ??

Discussion in 'ProcessGuard' started by MichaelE, Oct 12, 2004.

Thread Status:
Not open for further replies.
  1. MichaelE

    MichaelE Registered Member

    Joined:
    Nov 20, 2002
    Posts:
    79
    Location:
    V?ster?s Sweden
    In my PG3.0 I have under "Protection settings" only the "Protection Enabled" ticked.
    The "Block new and changed programs" is grayed out and can only be ticked when the "Executen Protection" is ticked.

    I have a feeling a change has taken place. But I am not sure??

    Can anybody help the old man up in Sweden :rolleyes:
    Michael
     
    MichaelE, Oct 12, 2004
    #1
  2. Bowserman

    Bowserman Infrequent Poster

    Joined:
    Apr 15, 2003
    Posts:
    510
    Location:
    South Australia
    Hi MichaelE :).

    "Block new and changed programs" is part of the "Execution Protection" hence it is greyed out when "Execution Protection" is disabled. Any new programs that try starting, or changes that have been made to a protected EXE will be blocked while "Block new and changed programs" is enabled :)

    Regards,
    Jade.
     
    Last edited: Oct 12, 2004
    Bowserman, Oct 12, 2004
    #2
  3. MichaelE

    MichaelE Registered Member

    Joined:
    Nov 20, 2002
    Posts:
    79
    Location:
    V?ster?s Sweden
    Bowserman
    Thank you for the clarification
    :D
    Michael
     
    MichaelE, Oct 12, 2004
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...