I don't want to Overwrite during Restore?

Discussion in 'Paragon Drive Backup Product Line' started by odiscussionhandle, Aug 16, 2011.

Thread Status:
Not open for further replies.
  1. odiscussionhandle

    odiscussionhandle Registered Member

    Joined:
    Aug 16, 2011
    Posts:
    1
    Using Paragon Advanced 2011 Free.

    I started a restore process and it bombed-out due to an error after approximately 3-hours. I now want to finish the process but the only way I can figure out how to do this is to initiate the restore process again, the same exact one I ran previously. But I don't really want to copy all of the files again, I just want the program to skip-over them and only copy the files that did not get copied last time.

    So, is there an option to prevent overwriting during a restore process?

    Or, is there a way to continue the previous restore from where it left off?

    I've certainly looked around and haven't found any options that will allow me to achieve my goals, so I'm asking here.

    Thanks in advance
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.