HELP! Cannot install Diskeeper

Discussion in 'ProcessGuard' started by paperinik3, May 26, 2004.

Thread Status:
Not open for further replies.
  1. paperinik3

    paperinik3 Registered Member

    Joined:
    Aug 10, 2003
    Posts:
    90
    I've upgraded Diskeeper from version 7 to version 8 Pro but when I try to install the upgrade PG doesn't allow the setup to run.Please take note that:
    a) Diskeeper 7 still runs without problems;
    b) Diskeeper is not protected;
    c) "Block all new....etc" is not ticked.
    What should I do?
    Anxious regards
     
    paperinik3, May 26, 2004
    #1
  2. ReGen

    ReGen Registered Member

    Joined:
    Jan 7, 2003
    Posts:
    61
    Location:
    Scotland UK
    I imagine Disk keeper installs itself as a service. I would disable PG or at least make sure ‘Block drivers and services from installing’ is deselected. Install DK8. Enable PG. (If you use PGs ‘Checksum protection’ also activate PGs learning mode). Reboot your PC. Run DK8. Deactivate PGs learning mode.
    Hope that helps!
     
    ReGen, May 26, 2004
    #2
  3. paperinik3

    paperinik3 Registered Member

    Joined:
    Aug 10, 2003
    Posts:
    90
    Hi ReGen,
    I followed your instructions (had to disable PG) and it worked: Diskeeper installed! Thank you so much and best regards.
     
    paperinik3, May 26, 2004
    #3
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...