Global journal record hook

Discussion in 'ProcessGuard' started by Chris12923, Nov 19, 2004.

Thread Status:
Not open for further replies.
  1. Chris12923

    Chris12923 Registered Member

    Joined:
    May 31, 2004
    Posts:
    1,097
    When using snagit 7.1 PG3 pops up and says that it tried to install a global journal record hook. I go into alerts tab and click allow global hook but it doesn't gray out it stays the same color and does not issue a permit command. Any ideas?

    Thanks,

    Chris
     

    Attached Files:

  2. Jason_DiamondCS

    Jason_DiamondCS Former DCS Moderator

    Joined:
    Nov 11, 2002
    Posts:
    1,046
    Location:
    Perth, Western Australia
    Try adding the file in the normal PROTECTION area rather than by clicking there. I think it will be possible to fix this GUI issue (DOS short filename) in the next version. However if you add that file the normal way, the alert will appear correctly.
     
  3. Chris12923

    Chris12923 Registered Member

    Joined:
    May 31, 2004
    Posts:
    1,097
    Thanks Jason for the fast response. It actually does give it the permission in the protection screen just doesn't show it on alert screen. Like you said just small bug.

    Thanks,

    Chris
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.