DDS9/533 - Bad Blocks

Discussion in 'Acronis Disk Director Suite' started by paul humphreys, Feb 22, 2005.

Thread Status:
Not open for further replies.
  1. paul humphreys

    paul humphreys Registered Member

    Joined:
    Sep 12, 2004
    Posts:
    23
    Hi All,

    Just updated to DDS9/533, all went well until I tried to resize a partition, I get the message "Can't resize a partition with bad blocks". I've done all the obvious things, (Scandisk, Defrag Etc.,) to try to rectify sitiuation to no avail.

    Any help would be very much appreciated.

    TIA - Paul H
     
  2. hylian lynk

    hylian lynk Guest

    you disk is going bad you have to low level format it to remove the bad blocks but you will have to replace it.
     
  3. paul humphreys

    paul humphreys Registered Member

    Joined:
    Sep 12, 2004
    Posts:
    23
    Hi hylian lynk,

    Have reformatted the partition in question. SMART status of drive is OK and I have been able to resize it now.

    Thanks for your input - Paul H
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.