Newbie with a question about unsupported structure?

Discussion in 'Acronis True Image Product Line' started by grhughes, Dec 22, 2004.

Thread Status:
Not open for further replies.
  1. grhughes

    grhughes Registered Member

    Joined:
    Dec 22, 2004
    Posts:
    8
    I just bought, downloaded, and installed ATE. When I select the Create Image Wizard I get "The disk contains an unsupported structure" message on disk one. My primary disk backed up just fine. The drive in question is a 250GB WD HD with less than 2Gb of data on it. Any suggestions as to a fix?
     
    grhughes, Dec 22, 2004
    #1
  2. TheQuest

    TheQuest Registered Member

    Joined:
    Jun 9, 2003
    Posts:
    2,304
    Location:
    Kent. UK by the sea
    Hi, grhughes

    I think it might be because you HDD is set as a Dynmic Disk rather than a Basic Disk, could you look in Disk Management to see if that is the Problem.

    Take Care,
    TheQuest :cool:
     
    TheQuest, Dec 22, 2004
    #2
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...