Help me One Clcik Restore (ATI Home v.11)

[ktt9854]

I'm using One Click Restore (ATI Home v.11), but when I restored I only see one partition on my disk. What's happen . And now I only want to restore FIRST partition. Can I do this ?. If anyone know this. plz help me ??
Thank you !!

[ktt9854]

Nobody help me

[MudCrab]

You're better off using the regular TI program if you want more control of exactly what gets restored where. If you use the One-Click Restore option, what you have in the image is restored to the drive. If you have one partition in the image and three on the drive, you'll only have the one partition after the restore is finished and the other two will be gone.

From the manual:

If a backup image is located on bootable media, you might have the choice of using Acronis One-Click Restore. This operation always restores the entire physical disk. Therefore, if your disk consists of several partitions, all of them must be included in the image. Any partitions missing from the image will be lost. Please make sure that the image contains all the disk data you plan to restore.

[ktt9854]

I have read your post and I thank you. But when I save my image, i have two (or three or four) partition and when I use One Click Restore, my drive only have ONE PARTITION. Can you replace it

[MudCrab]

If you had multiple partitions on your drive, created a backup that contained only one of them and then did a One-Click Restore using that image, the other partitions would be deleted.

You may be able to recover the partitions or data using recovery software. You can't recover it using TI if you didn't back it up in the first place.