BelArc Advisor 6.1 (Informational only)

Discussion in 'ProcessGuard' started by spy1, Feb 4, 2004.

Thread Status:
Not open for further replies.
  1. spy1

    spy1 Registered Member

    Joined:
    Dec 29, 2002
    Posts:
    3,139
    Location:
    Clover, SC
    If you're running PG and you want to get BA v6.1 to install, you're going to have to UN-check "Block Drivers" to do so. (Remember to turn it back on afterwards!).

    The program functions normally with "Block Drivers" check-marked after it's been installed - and does not generate any PG log entries when you run it. Pete
     
    spy1, Feb 4, 2004
    #1
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...