|
|
#1
July 7th, 2007, 06:08 PM
|
|||
|
|||
NOD32 for DOS and NTFSPro
I am trying to use the NOD32 for DOS version to scan NTFS drives configured for read/write with NTFSforDOS (by Winternals). However when I run NOD32 for DOS its not seeing the NTFS partition. It only picks up the CD Rom and floppy drives. Any thoughts?
Joe |
|
#2
July 9th, 2007, 11:32 AM
|
|||
|
|||
|
Re: NOD32 for DOS and NTFSPro
Quote:
please check the installation that is NOD 32 for DOS, and ensure that is well and NTFS drives as well.NOD 32 for DOS version has supported NTFS. |
|
#3
July 9th, 2007, 02:40 PM
|
|||
|
|||
|
Re: NOD32 for DOS and NTFSPro
I should have been more specific. I have built a Boot CD with Nod32 for dos on it. I am using the CD to fix dead systems with virus / spyware infections. My hope is to boot off the CD and then run NOD32 for DOS to clean it. Maybe this is the problem. I don't understand why it can see the floppy and cd rom but not the hard drive partition.
|
|
#4
July 9th, 2007, 03:26 PM
|
|||
|
|||
|
Re: NOD32 for DOS and NTFSPro
Sata or Pata drives?
|
|
#5
July 9th, 2007, 08:24 PM
|
|||
|
|||
|
Re: NOD32 for DOS and NTFSPro
PATA but could be SATA. Very strange. Once I load the NTFSPro driver and can do anything to the drive but for some reason NOD32 is not seeing them.
|
|
#7
July 11th, 2007, 08:50 AM
|
|||
|
|||
|
Re: NOD32 for DOS and NTFSPro
Haven't tried it. Will give it a shot. This may not help me in every situation though, if I don't have the admin password or the system will not boot.
|
| « Previous Thread | Next Thread » |
| Thread Tools | Search this Thread |
|
|
