When i backup using acronis , i then have to go and defragment the drive holding the file - can acronis lay down a backup file that is not so...
new computer with sata drives- installed xp and cloned drive no problem...finished putting data on and tried to clone again- it says 'operation...
thanks i will - but now i can run it with both drives disconnected ! satrted anew thread about the commands and where they are saved,, v many...
So I fixed my blank boot up screen problem - or rather acronis support fixed it... I attached my old crt screen which showed the boot up cd...
finally - it works ! ok here is what you do youn plug an old crt screen in and boot up on the cd then you hit f11 and issue a linux command...
many thanks for that - i contacted ctx and they say my lcd is a simple screen which just works or doesnt...it hasnt got modes for different kinds...
ps my lcd screen is ctx and works fine without special drivers using standard xp vga driver-- i have tried it with the vga driver and the...
Hum tried resetting my lcd screen - no effect... I ran a clone from acronis inside windows and it rebooted (without the cd) and the black screen...
the boot cd was created after i installed anew driver for the lcd screen...do i have to just copy the driver to the cd ? which folder ? alan
If I use an old crt monitor i can see the recovery boot cd is working fine and goes right through to the operations screen. If I use my lcd screen...
always booted ok from cd but i just did a clone disk and then later wanted to boot from cd and it stopped at the 3 choices screen....rebooted and...
Separate names with a comma.