I have an eMachines and was also unable to clone that 2-partition drive. I finally deleted the restoration partition, then TI would clone properly.
Follow Up.... I finally replaced the CMOS battery (it was low, but maybe not quite dead), did a "clear NV RAM" and restored my system from an...
I believe that's ancient info. I've always swapped HDs freely without concern to drive letters. Just set the drives to CS and Windows gets it right.
Bootable TI CD. I wasn't trying to boot from the "cloned to" HD. I booted from the source HD, but Windows didn't recognize that a HD, D:, was...
Pardon? I never do that. I just copy c: to d: and continue with c: as primary.
I cloned from boot disk, and it appeared to be completed normally. However, after cloning the system would not recognize the 2nd disk. Unless...
Tried to clone my HD #1 -> #2. The setup appeard OK, but after reboot it went directly to the "congratulations...", finished page without copying...
Alexy, Your kidding, right? You really don't see how poorly worded those pages are? To do this correctly, I'll need to install a different HD...
A general comment..... I recently purchased ATI and did some Image Creation and Image Restore. And while I find the software to work as...
Is there a better, more reliable way to make an image of the entire HD? Either from the boot disk or from Windows?
Thanks for the response Alexey, 1. Using build 903 2. OS is WinXP Home. One HD with one partition. Image of that one partition, which is...
I've apparently got the "common" problem... When I try to restore, I get the message, "This is not the last created volume of the image archive....
Separate names with a comma.