MEASY seems in loop in analysis

[rechmbrs]

I started MEASY over 2 hours ago and it is just sitting. Seems to be in an analysis phase. Task Manager shows a great deal of disk activity. I'm attempting to copy a 60gb to 120gb drive. When will the next step start?
The output drive had been formatted and partitioned before.

Appreciate comments on my concerns.

RONC

[rechmbrs]

The number of disk i/os has exceeded 3,000,000,000 and the Disk Clone Wizard has not opened to let me enter info about the disks. All I see is the Processing please wait and moving hand clock. Is there something I might have missed previous to running. Destination drive is formatted as NTFS and has two partitions but no data.

Am I paranoid related to this? Should I be. Program like Ghost 9 would be finished copying image by now.

Thanks,
RONC

[rechmbrs]

Don't know what problem was but I moved the destination drive from the boot drive cable where is was a slave to the other eide cable as slave. Rebooted and all seems well. Job is about half done.

RON C

[Acronis Support]

Hello Ron,

Thank you for your interest in Acronis System Transferring Software (http://www.acronis.com/homecomputing/products/migrateeasy/).

The problem seems to be hardware-related. During the analysis Acronis Migrate Easy needs a lot of information about disks and the transferring rate may be very low for some reason.

Thank you.
--
Ilya Toytman

[rechmbrs]

Job finished fine and I've now taken old drive and stored it away. New drive is sure a pleasure.

Thanks for your help and good program.

RON C