PDA

View Full Version : Is there a problem ?


carlspy
July 24th, 2005, 10:59 AM
When I open an e-mail message,on the bottom of it reads "This message was checked by Nod32 antivirus system". BUT when I go to the Nod32 Control Center and check on the EMON status, the status indicates that ZERO files were Cleaned , Infected , or even Scanned. Is there a problem ? I would expect the status to show the files had been at least Scanned. ????

carlspy
July 24th, 2005, 11:04 AM
Yes I am using Outlook Express and the EMON enabled box is checked

ronjor
July 24th, 2005, 11:08 AM
carlspy

Your pop3 email is being scanned by Imon. From the faq.

What is EMON?

EMON (Email MONitor), a complementary resident module, scans e-mails incoming via MAPI interface. MAPI interface is used e.g. in the following e-mail clients: Microsoft Outlook 95, 97, 2000 (not Outlook Express) in the Corporate mode and in MS Exchange. MS Outlook 2002(Office XP) and Outlook 2003 are not supported in the current version of EMON. MAPI interface is used also when receiving e-mails from the Microsoft Exchange Mail Server via the Exchange protocol.

What is IMON?

IMON is a multi-purpose scanner working on Winsock level. It takes advantage of the unprecedent advanced heuristics and serves for:

1. scanning email received through the POP3 protocol
IMON works fully automatically with any POP3-based mail client without needing to configure anything (in very rare cases, you may need to add another POP3 port which can be done in IMON setup). Possible infiltrations are detected before infected email is stored in your mail client's mailbox and IMON offers you an action to take (this is the default setting, but IMON can be set up to take the desired action automatically). By default, IMON modifies the subject of infected email by putting information about the virus before the original subject. This feature can later be used in your mail client filter (e.g. you can define a rule to delete all email previously containing a virus .

http://nod32.com/support/nodfaq2.htm

Oddbod
July 24th, 2005, 11:08 AM
Hi carlspy.

EMON is used for Outlook mail client, IMON is used for Outlook Express & general POP3 mail access, if you check IMON you will see yuor mailcount increase.

I use OE as amil client & unticked EMON during the install as i dont need it.

HTH

carlspy
July 24th, 2005, 11:44 AM
Thank You both for your quick and Helpful replies. Just one more question:do you know if IMON would work properly if I were to switch from OE to Thunderbird ?? Thanks Again

ronjor
July 24th, 2005, 11:46 AM
It will work fine. I personally use Calypso with all mail being scanned.

carlspy
July 24th, 2005, 12:29 PM
Thanks, I'm going to try Thunderbird :)