CHX-I & Ingres Filters

[Jazzie1]

Hi all!

Heres a tip for all of you that downloaded the 'Treewalk' filter set:

http://members.shaw.ca/BIND-PE_and_ICS/chxi/2.6Filters.zip

and want to take each individual reference to the Ingres Filter (which there is a lot of them) into to one filter:

http://www.wilderssecurity.com/attachment.php?attachmentid=161949&stc=1

Your Ingres filter list is found on the left side of the CHX-I management console, under 'Defined Lists'. The list could be pointed towards any ip address/subnet as desired.....

Regards
Jazzie

[khazars]

I don't have any ingress showing in the defined lists, just IP and port lists!

[Jazzie1]

Khazars-

Just have to create one, like the following:

http://www.wilderssecurity.com/attachment.php?attachmentid=161950&stc=1

Regards

Jazzie

[Jaws]

Hi Jazzie,

Are those images from the CHX 3.0 Beta? If so, would you care to post images of the Conditions and Schedule tabs?

Regards,

Jaws

[Jazzie1]

HI Jaws! Yes, these are the images from beta 3.0. But, I had the 2.8 version set up the same with the Ingres filters. I would post more images, but the limatations for images on the board permits that. I think I am at my max! :) Anyways, I leave the conditions constant without a list, because of my LAN and scheduling is off...

Regards
Jazzie

[Arup]

Speaking of filters, the sample WAN set from IDRCI works nicely on a stand alone workstation, you get full stealth at GRC and Sygate.

[khazars]

ok, thx jazzie for that info!