Initialization Problem

[Rainwalker]

Greetings....Installed V3 with unlock code then first got 'Mutex 2' error,,,rebooted then PG was showing 'Error in initialization. Check dcuserprot.exe'. I tried to look at dcuserprot and got a blank command prompt window.... ???

[Pilli]

Hi RainWalker, Did you reboot before putting you code in?
If not then the service would not be running and DCSuserProt would not be able to run.
Try rebooting and entering your code.

Cheers. Pilli

[Rainwalker]

Hi Pilli.....should i remove and start over? I don't see where to put in code....looked in folder.

[Pilli]

Hi Rainwalker, On the right of the "Main" menu item "Register" if I remember correctly.

If you cannot see it then you may need to uninstall & reinstall first :)

HTH Pilli - I'm off now until tomorrow - Best of luck :)

[Rainwalker]

Hey Pilli, welcome back.................Tried that ..nothing changed...downloaded again just in case....nothing changed....did a system restore....that sorted it :)
Thanks :)