PlaStiK
October 28th, 2004, 07:05 AM
I recently installed Drivecrypt plus pack and encrypted both my C and D partitions. Yesterday night I shut down down the computer normaly but in the morning it refused to load Windows with a Loader error 3. To cut a long story short, I used the floppy based tool to decrypt my boot partition and used Console to fix the problem. However, after booting into Windows again the Drivecrypt control panel cannot start, saying that the 'dcpp.sys' or 'dcpp2k.sys' driver is not loaded. The driver dcpp2k.sys is in the \system32\drivers folder, I checked. this makes me unable to see my D partition and all 100GB of data on it. I tried to install drivecrypt on a second hard disk where it opens normally, but then when i try to import my keystore from the affected drive it says that it is either invalid or the password is wrong, which obviously it is not. The keystore is in the now un-encrypted C drive by the way. So, i have no way to decrypt the D partition for now and i really need the data on that drive. Is there a solution to this problem or should i start writting my suicide note? :)
Thank you for your time.
edit: Drivecrypt PP version is 2.8, my system is Windows 2000 SP4
Thank you for your time.
edit: Drivecrypt PP version is 2.8, my system is Windows 2000 SP4